24LC41A-SLASHP datasheet(14/18 Pages) MICROCHIP

14 / 18 page

24LC41A

DS21176D-page 14

 2003 Microchip Technology Inc.

8.0

PIN DESCRIPTIONS

8.1

DSDA

This pin is used to transfer addresses and data into and

out of the DDC Monitor Port, when the device is in the

Bidirectional mode. In the Transmit-only mode, which

only allows data to be read from the device, data is also

transferred on the DSDA pin. This pin is an open drain

terminal, therefore the DSDA bus requires a pull-up

resistor to VCC (typical 10K

Ω for 100 kHz, 2KΩ for 400

kHz).

For normal data transfer in the Bidirectional mode,

DSDA is allowed to change only during DSCL or MSDA

low. Changes during DSCL high are reserved for

indicating the Start and Stop conditions.

8.2

DSCL

This pin is the clock input for the DDC Monitor Port

while in the Bidirectional mode, and is used to synchro-

nize data transfer to and from the device. It is also used

as the signaling input to switch the device from the

Transmit-only mode to the Bidirectional mode. It must

remain high for the chip to continue operation in the

Transmit-only mode.

8.3

VCLK

This pin is the clock input for the DDC Monitor Port

while in the Transmit-only mode. In the Transmit-only

mode, each bit is clocked out on the rising edge of this

signal. In the Bidirectional mode, a high logic level is

required on this pin to enable write capability.

8.4

MWP

This pin is used to write-protect the 4K memory array

for the Microcontroller Access Port.

This pin must be connected to either VSS or VCC.

If tied to Vss, normal memory operation is enabled

(read/write the entire memory).

If tied to VCC, write operations are inhibited. The entire

memory will be write-protected. Read operations are

not affected.

8.5

MSCL

This pin is the clock input for the Microcontroller Access

Port, and is used to synchronize data transfer to and

from the device.

8.6

MSDA

This pin is used to transfer addresses and data into and

out of the Microcontroller Access Port. This pin is an

open drain terminal, therefore the MSDA bus requires

a pull-up resistor to VCC (typical 10K

Ω for 100 kHz,

Ω for 400 kHz).

MSDA is allowed to change only during MSCL low.

Changes during MSCL high are reserved for indicating

the Start and Stop conditions.

24LC41A-/P bảng dữ liệu(PDF) 14 Page - Microchip Technology

24LC41A-/P bảng dữ liệu(HTML) 14 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18

bảng dữ liệu tải về

Link URL