TDA4887PS datasheet(32/68 Pages) PHILIPS

32 / 68 page

2001 Oct 19

Philips Semiconductors

Product speciﬁcation

160 MHz bus-controlled monitor video

preampliﬁer

TDA4887PS

11 I2C-BUS PROTOCOL

Table 1

Slave address

Notes

1. Address bit.

2. Write bit.

Table 2

Slave receiver format

Notes

1. START condition.

2. A = acknowledge.

After an intermediate power dip all registers are set to their initial values (see note 3 at Table 4) and an internal

power-on reset bit will be set with the consequence that the device will give no acknowledge on the data byte after

a first addressing. The power-on reset bit will be reset if the control register is addressed. It is recommended to then

refresh all registers by using the auto-increment function.

3. All subaddresses within the range 00H to 0BH are automatically incremented. The subaddress counter wraps

around from 0BH to 00H. For subaddresses within the range 80H to 8FH no auto-increment takes place.

Subaddresses outside the ranges 00H to 0BH and 80H to 8BH are acknowledged by the device but no

auto-increment or any other internal operation takes place.

4. Single data byte in case of no auto-increment of subaddresses. More than one data byte with auto-increment of

subaddresses.

5. STOP condition.

A6(1)

A5(1)

A4(1)

A3(1)

A2(1)

A1(1)

A0(1)

W(2)

10001000

S(1)

SLAVE ADDRESS A(2)

SUBADDRESS(3) A

DATA BYTE(4) AP(5)

TDA4887PS bảng dữ liệu(PDF) 32 Page - NXP Semiconductors