C8051F340 datasheet(65/288 Pages) SILABS

65 / 288 page

Rev. 1.0

C8051F340/1/2/3/4/5/6/7

Positive Hysteresis Voltage

(Programmed with CP0HYP Bits)

Negative Hysteresis Voltage

(Programmed by CP0HYN Bits)

VIN-

VIN+

INPUTS

CIRCUIT CONFIGURATION

CP0+

CP0-

CP0

VIN+

VIN-

OUT

VOH

Positive Hysteresis

Disabled

Maximum

Positive Hysteresis

Negative Hysteresis

Disabled

Maximum

Negative Hysteresis

OUTPUT

VOL

Figure 7.2. Comparator Hysteresis Plot

Comparator hysteresis is programmed using Bits3-0 in the Comparator Control Register CPTnCN (shown

in SFR Definition 7.1 and SFR Definition 7.4). The amount of negative hysteresis voltage is determined by

the settings of the CPnHYN bits. As shown in Figure 7.2, various levels of negative hysteresis can be

programmed, or negative hysteresis can be disabled. In a similar way, the amount of positive hysteresis is

determined by the setting the CPnHYP bits.

Comparator interrupts can be generated on both rising-edge and falling-edge output transitions. (For Inter-

rupt enable and priority control, see

Section “9.3. Interrupt Handler” on page 91.) The CPnFIF flag is set

to ‘1’ upon a Comparator falling-edge, and the CPnRIF flag is set to ‘1’ upon the Comparator rising-edge.

Once set, these bits remain set until cleared by software. The output state of the Comparator can be

obtained at any time by reading the CPnOUT bit. The Comparator is enabled by setting the CPnEN bit to

‘1’, and is disabled by clearing this bit to ‘0’.

C8051F340 bảng dữ liệu(PDF) 65 Page - Silicon Laboratories