L6701 datasheet(40/44 Pages) STMICROELECTRONICS

40 / 44 page

16 Layout Guidelines

L6701

40/44

16.3

Embedding L6701-based VRs

When embedding the VR into the application, additional care must be taken since the whole VR

is a switching DC/DC regulator and the most common systems in which it has to work are

digital systems such as MB or similar. In fact, latest MB has become faster and powerful: high

speed data bus are more and more common and switching-induced noise produced by the VR’

MOSFETs can affect data integrity if not following additional layout guidelines. Few easy points

must be considered mainly when routing traces and planes in which high switching currents

flow (high switching currents cause voltage spikes across the stray inductance of the trace

causing noise that can affect the near traces):

Keep safe guarding distance between high current switching VRD traces and data buses,

especially if high-speed data bus to minimize noise coupling.

Keep safe guard distance or filter properly when routing bias traces for I/O sub-systems that

must walk near the VRD.

Possible causes of noise can be located in the PHASE connections, MOSFET gate drive and

Input voltage path (from input bulk capacitors and HS drain). Also PGND connections must be

considered if not insisting on a power ground plane. These connections must be carefully kept

far away from noise-sensitive data bus.

Since the generated noise is mainly due to the switching activity of the VR, noise emissions

depend on how fast the current switches. To reduce noise emission levels, it is also possible, in

addition to the previous guidelines, to reduce the current slope by properly tuning the HS gate

resistor and the PHASE snubber network.

L6701 bảng dữ liệu(PDF) 40 Page - STMicroelectronics