SMSC DS – USB97CFDC2-01

Page 15

Rev. 02-27-07

DATASHEET

8

DC PARAMETERS

MAXIMUM GUARANTEED RATINGS

Operating Temperature Range........................................................................................................................... 0

Storage Temperature Range ............................................................................................................................-55

Lead Temperature Range (soldering, 10 seconds) ..................................................................................................... +325

Negative Voltage on any pin, with respect to Ground......................................................................................................-0.3V

Note 1: Maximum voltage on all I type Inputs and the IS inputs, OD12 and OD24 outputs for floppy disk drive interface is

5.25V

*Stresses above the specified parameters could cause permanent damage to the device. This is a stress rating only and

functional operation of the device at any other condition above those indicated in the operation sections of this

specification is not implied.

Note 2: When powering this device from laboratory or system power supplies, it is important that the Absolute Maximum

Ratings not be exceeded or device failure can result. Some power supplies exhibit voltage spikes on their outputs when

the AC power is switched on or off. In addition, voltage transients on the AC power line may appear on the DC output.

When this possibility exists, it is suggested that a clamp circuit be used.

PARAMETER

SYMBOL

MIN

TYP

MAX

UNITS

COMMENTS

I Type Input Buffer

Low Input Level

High Input Level

2.0

0.8

V

V

TTL Levels

ICLK Input Buffer

Low Input Level

High Input Level

2.2

0.4

V

V

Input Leakage

(All I and IS buffers)

Low Input Leakage

High Input Leakage

-10

-10

+10

+10

uA

uA

O8 Type Buffer

Low Output Level

High Output Level

Output Leakage

2.4

-10

0.4

+10

V

V

UA

I/O8(P) Type Buffer

Low Output Level

High Output Level

Output Leakage IO8

IO8P

2.4

-10

-50

0.4

+10

+10

V

V

µA

µA

IOL = 8mA

IOH = -4mA

VIN = 0 to Vcc (Note 1)

VIN = 0 to Vcc (Note 1)