WM8976 datasheet(76/108 Pages) WOLFSON

76 / 108 page

WM8976

Pre-Production

PP Rev 3.0 April 2006

POWER SUPPLIES

The WM8976 can use up to four separate power supplies:

AVDD and AGND: Analogue supply, powers all analogue functions except the speaker output and

mono output drivers. AVDD can range from 2.5V to 3.6V and has the most significant impact on

overall power consumption (except for power consumed in the headphone). A large AVDD slightly

improves audio quality.

SPKVDD and SPKGND: Headphone and Speaker supplies, power the speaker and mono output

drivers. SPKVDD can range from 2.5V to 5V. SPKVDD can be tied to AVDD, but it requires separate

layout and decoupling capacitors to curb harmonic distortion. With a larger SPKVDD, louder

headphone and speaker outputs can be achieved with lower distortion. If SPKVDD is lower than

AVDD, the output signal may be clipped.

DCVDD: Digital core supply, powers all digital functions except the audio and control interfaces.

DCVDD can range from 1.71V to 3.6V, and has no effect on audio quality. The return path for

DCVDD is DGND, which is shared with DBVDD.

DBVDD can range from 1.71V to 3.6V. DBVDD return path is through DGND.

It is possible to use the same supply voltage for all four supplies. However, digital and analogue

supplies should be routed and decoupled separately on the PCB to keep digital switching noise out

of the analogue signal paths.

DCVDD should be greater than or equal to 1.9V when using the PLL.

WM8976 bảng dữ liệu(PDF) 76 Page - Wolfson Microelectronics plc