CS43L21 datasheet(47/63 Pages) CIRRUS

47 / 63 page

DS723A1

CS43L21

6.10

Beep Configuration & Tone Configuration (Address 14h)

Note: The DATA_SEL[1:0] bits in reg09h must be set to ‘01’b to enable function control in this register.

Repeat Beep (REPEAT)

Default: 0

0 - Disabled

1 - Enabled

Function:

This bit is used in conjunction with the BEEP bit to mix a continuous or periodic beep with the analog output.

Refer to Figure 10 on page 26 for a description of each configuration option.

Beep (BEEP)

Default: 0

0 - Disabled

1 - Enabled

Function:

This bit is used in conjunction with the REPEAT bit to mix a continuous or periodic beep with the analog

output. Note: Re-engaging the beep before it has completed its initial cycle will cause the beep signal to

remain ON for the maximum ONTIME duration. Refer to Figure 10 on page 26 for a description of each con-

figuration option.

Treble Corner Frequency (TREB_CF[1:0])

Default: 00

00 - 5 kHz

01 - 7 kHz

10 - 10 kHz

11 - 15 kHz

Function:

The treble corner frequency is user selectable as shown above.

Bass Corner Frequency (BASS_CF[1:0])

Default: 00

00 - 50 Hz

01 - 100 Hz

10 - 200 Hz

11 - 250 Hz

Function:

The bass corner frequency is user-selectable as shown above.

432

REPEAT

BEEP

Reserved

TREB_CF1

TREB_CF0

BASS_CF1

BASS_CF0

TC_EN

CS43L21 bảng dữ liệu(PDF) 47 Page - Cirrus Logic

CS43L21 bảng dữ liệu(HTML) 47 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

bảng dữ liệu tải về

Link URL