ELECTRONICS

FCI Electronics

Manual Part No. 415988-001

Issued: Date (03/12/99)

Page 11 of 18

Rev. 05/07/01 ECR V10337

Revision B

K\DCU\Manuals

Anvil Installation

NOTE: When replacing the anvils, be sure that the part numbers for the new anvils are the same

as those being replaced.

1. Insert the 3/32-inch Allen wrench through the access hole in the adjustable tool holder and into

the socket-head setscrew (see Figure 9). Then turn the setscrew 1/4-turn counterclockwise to

unlock the adjusting collar.

Figure 9

2. Insert the turned-down end of the 3/32-inch Allen wrench or a pin, approximately 1/16-inch in

diameter, into one of the holes in the adjusting collar (see Figure 10). Then rotate the collar

about 1/2-turn counterclockwise.

Figure 10

3. Reinstall the anvil holder onto the hand and tighten the attaching cap screw.

CAUTION

To prevent the anvils from being damaged during alignment, place a piece of paper,

plastic bag material, or cellophane over the anvils.

PDM: Rev:B

Released

STATUS:

Printed: Dec 19, 2002