DFE252012P-2R2M datasheet(34/44 Pages) MICROCHIP

34 / 44 page

MCP16501

DS20006388A-page 34

 2020 Microchip Technology Inc.

5.6

nSTRT Capacitor for Automatic

Turn-On on VIN Ramping

As shown in Figure 4-1, it is possible to configure the

MCP16501 for automatic start-up upon input voltage

(VIN) ramping/power cycling by connecting a capacitor

on pin nSTRT. The purpose of the capacitor (C in

Figure 4-1) is to delay the rise of the nSTRT pin when

VIN ramps up, such that after the VIN pin voltage

(connected to VIN) has stabilized, the logic level of the

nSTRT pin will still be low long enough to be interpreted

as a valid start-up event (i.e., longer than t1; see

Section 4.4.1 “Typical Power-up Sequence and

Timing”).

Under the assumption that the VIN ramping is much

shorter than the rise time of the nSTRT pin voltage, the

recommended amount of capacitance needed for

generation of a valid start-up event is given by the

formula in Equation 5-2:

EQUATION 5-2:

After the selection of capacitor C, the resulting C

RPU_nSTRT time constant must be compared to the

actual VIN ramping time to verify that indeed the nSTRT

rise time is much slower.

The time constant C RPU_nSTRT should be at least one

order of magnitude larger than the slowest VIN ramping

time expected in the application. If this is not true, the

capacitor value C must be increased further. Using a

1 µF capacitor for C, the C RPU_nSTRT time constant

will be 40 ms, which is adequate for VIN ramping times

in the ms range.

t1 Δt

RPU_nSTRT

VIN

VIN VIL_nSRT

–

------------------------------------





log

⋅

--------------------------------------------------------------------------------------

t1 Δt

RPU_nSTRT

10.36

–

-------------------





log

⋅

--------------------------------------------------------------------

2.24

t1 Δt

RPU_nSTRT

---------------------------

⋅

Where:

RPU_nSTRT = nSTRT Pin Pull-up Resistance (40 kΩ typical value)

VIL_nSTRT = nSTRT Logic Low Input Voltage (0.36 VIN, maximum value)

VIN = Input Voltage (VIN pin is connected to the voltage VIN)

t1 = Delay from nSTRT Falling to First Output VOUT1 Starting (≈ 0.5 ms); see Section 4.4.1

“Typical Power-up Sequence and Timing”

Δt = Additional Delay from VIN Voltage established to the Detection of a Logic Low Level on

nSTRT (due to internal logic wake-up time): ≈ 100 µs

DFE252012P-2R2M bảng dữ liệu(PDF) 34 Page - Microchip Technology

DFE252012P-2R2M bảng dữ liệu(HTML) 34 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

bảng dữ liệu tải về

Link URL