F39-TGR-CVL-B-10-R datasheet(59/98 Pages) OMRON

59 / 98 page

SECTION 13

Checkout and test procedure

13-1 Checkout Procedure

Once the MS4800 system has been configured, mounted, aligned and prop-

erly connected to the machine control system, the initial Checkout Procedure

detailed in Appendix A must be performed by qualified personnel. A copy of

the checkout results should be kept with the machine records.

13-2 Test Procedure

!WARNING The tests outlined in the Test Procedure in Appendix B must be performed at

installation, according to the employer's regular inspection program and after

any maintenance, tooling change set up, adjustment or modification to the

MS4800 system or the guarded machine. Where a guarded machine is used

by multiple operators or shifts, it is suggested that the test procedure be per-

formed at each shift or operator change. Testing ensures that the light curtain

and the machine control system work properly to stop the machine. Failure to

test properly could result in serious injury to personnel.

The test procedure must be performed by qualified personnel. To test the

MS4800 system with fixed blanking and floating blanking disabled, use the

OMRON STI supplied test object. For applications where fixed blanking or

floating blanking is enabled, see Table in chapter 5-3-1 The effect of Fixed or

Floating Blanking on minimum object resolution to determine the proper size

of the test object.

When using a MS4800 system set for Automatic Start Mode operation, in con-

junction with an OMRON safety relay module, it is necessary to verify that the

outputs of the safety relay unit can properly change state by causing an inten-

tional beam break at least every change of shift or 24 hours of operation.

13-3 Using the test object

When using the test object, guide it through

the detection zone as shown:

START

STOP

F39-TGR-CVL-B-10-R bảng dữ liệu(PDF) 59 Page - Omron Electronics LLC