L99LD20 datasheet(9/61 Pages) STMICROELECTRONICS

9 / 61 page

DS11366 Rev 3

9/61

L99LD20

Introduction

Figure 4. Connection diagram

Table 1. Pin functionality

Pin #

Name

Function

1V3V3

Output of the 3.3 V regulated internal supply. Connect a low ESR

capacitor (4.7 µF) close to this pin.

TEST

Internal function. Left open.

3CSN

Chip Select Not (active low) for SPI communication. It is the selection pin

of the device. It is a CMOS compatible input.

PWMCLK

Clock input for the internal PWM dimming generator.

SGND

Signal Ground connection.

SCK

Serial Clock for SPI communication. It is a CMOS compatible input.

VSPI

Connection to external 3.3 V or 5 V supplies voltage.

The external supply powers SPI interface and the I/O signal pins to the

microcontroller. It is suggested to connect 100nF capacitor close to this

pin.

8SDI

Serial Data Input for SPI communication. Data is transferred serially into

the device on SCK rising edge.

9SDO

Serial Data Output for SPI communication. Data is transferred serially

out of the device on SCK falling edge.

DIN

Direct input pin.

LX2F

Connection to the switching source node of the buck2. This pin must be

connected to external free-wheeling diode.

LX2S

Kelvin connection to the switching source node of the buck2. This pin

has to be connected to external bootstrap capacitance.

L99LD20 bảng dữ liệu(PDF) 9 Page - STMicroelectronics

L99LD20 bảng dữ liệu(HTML) 9 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61

bảng dữ liệu tải về

Link URL