7

H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Presses\AP-K2N\TS010-00 AP-K2N Operation

Manual.doc

3.3 Mounting the Terminal Reel

Mount the terminal reel to the reel hanger so that the

terminal barrels are facing the reel guide, then feed the

terminals through the terminal guide to the applicator.

Mounting the MK-L Applicator

Step 1

Push down the tension lever and engage the hook with

the feed plate so that the pressure pad rises. Feed the

terminal strip between the guide rails.

Step 2

Place the first terminal at the correct crimping position.

Release the hook from the feed plate to allow the

pressure pad to apply pressure on the strip.

Mounting the MKS-L or MKS-LS

Applicator

Step 1

Rotate the wing bolt clockwise to raise the pressure

plate. Feed the terminal strip between the guide rails.

Step 2

Place the first terminal in position so that the terminal is

centralised over the anvil. Rotate the wing bolt counter-

clockwise to lower the pressure plate so that pressure is

applied to the terminal.