ML2240 datasheet(4/24 Pages) OKI

4 / 24 page

FEDL2240DIGEST-02

OKI Semiconductor

ML2240 Family

4/24

PIN DESCRIPTIONS

80-pin Plastic TQFP

Symbol

Type

Description

1-3, 5, 66-68,

73-80

RD14-RD0

Data pins to connect an external memory.

Data is input when the

ROE pin is at "L" level. Input data from outside

is not accepted when the

ROE pin is at "H" level. The RD14-RD8 pins

do not accept input data from outside when the

BYTE pin is at "L"

level.

RD15/A-1

I/O

Data pin of the externally connected memory when

BYTE pin is at “H”

level.

The data is input when the

ROE pin output is at "L" level. When the

ROE pin output is at "H" level, input data from outside is not accepted.

This pin becomes an address A-1 output pin when the device is in byte

mode. The address is output when the

RCS pin is at "L" level. When

the

RCS pin is at "H" level, this pin is in a high impedance state.

BYTE

Word/byte switching pin of the externally connected memory.

When

BYTE pin = “L” level: Byte mode

When

BYTE pin = “H” level: Word mode

8-20, 22-24,

28-30, 32-35

RA22-RA0

Address pins of an externally connected memory.

When

RCS pin = “H”: High impedance

Wired to a crystal or ceramic oscillator.

Contains a feedback resistor of around 1 M

Ω between this XT pin and

XT pin (pin 27).

When using an external clock, input the clock from this pin.

Wired to a crystal or ceramic oscillator.

When using an external clock, keep this pin open.

RESET

When “L” level is input to this pin, the device is reset to the initial state.

The oscillation stops, and AOUT output goes into “GND” level.

CPU interface write signal.

When

CS pin is at “H” level, the WR signal cannot be input to the

device.

CPU interface read signal.

For parallel input interface, a status signal for each channel is output

from the D0-D7 pins when the

RD pin is at "L" level. For the serial

input interface, a status signal for each channel is output from the

D5/D0 pin. This pin has a pull-up resistor built-in.

CPU interface chip select pin.

When

CS pin is at “H” level, the WR, and RD signals cannot be input to

the device.

41-44

D3/STA3

D2/STA2

D1/STA1

D0/STA0

I/O

CPU interface data bus pins in the parallel input interface become

data input pins when

WR is at “L” level.

They become channel status output pins in the serial input interface.

These pins also become channel status output pins when

RD is at “L”

level.

ML2240 bảng dữ liệu(PDF) 4 Page - OKI electronic componets

ML2240 bảng dữ liệu(HTML) 4 Page - OKI electronic componets

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

bảng dữ liệu tải về

Link URL