L9026 datasheet(20/60 Pages) STMICROELECTRONICS

tên linh kiện	L9026

Giải thích chi tiết về linh kiện	Automotive configurable multi-channel relay driver 2HS 6HS/LS

PDF	60 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

20 / 60 page

Power stages

There are two fixed high-side channels and six channels which can be used either as low-side or as high-side

switches. During the diagnosis in OFF State, the sequences of operations (pull-up or pull-down current source

activation) are determined according to the SPI settings of CFG_0 register.

For the configurable channels, when in high-side configuration, the load is connected between ground and source

of the power transistor (pins SOURCEn, n = 2...7) while the drains (pins DRAINn, n = 2...7) can be connected to

any potential between ground and VBATT.

In low-side configuration, the source of the power transistors must be connected to GND pin potential (either

directly or through a reverse current blocking diode).

The configuration can be chosen for each of these configurable channels individually via SPI.

Figure 8. HS driver (left) and LS driver (right) configuration

7.1

Operating modes

The ON-state resistance RDS(ON) depends on the supply voltage as well as the junction temperature TJ.

7.1.1

Switching resistive modes

When switching resistive loads, the following switching times and slew rates can be considered.

L9026

Power stages

DS13397 - Rev 5

page 20/60

L9026 bảng dữ liệu(PDF) 20 Page - STMicroelectronics