Maxim Integrated │ 2

www.maximintegrated.com

Evaluates: MAXPICO2PMB#

MAXPICO2PMB Adapter Board

Quick Start

Required Equipment

Note: In the following sections, software-related items are

identified by

bold text. Text in bold refers to items directly

from the install of adapter board software. Text which is

bold and underlined refers to items from the Windows

operating system.

● MAXPICO2PMB adapter board with the latest firmware

● USB A to Micro-B cable

● Windows 8/10 PC with USB ports

● EV kit or demo board under evaluation

Procedure

The adapter board is fully assembled and tested. Use the

following steps to verify board operation.

Caution: Do

not turn on the power supply until all connections are

completed.

1) Visit

https://www.maximintegrated.com to down-

load the latest version of the adapter board software,

PicoRegMapToolVxxx.ZIP located on the

MAXPICO2PMB adapter board web page. Download

the adapter board software to a temporary folder and

unzip the ZIP file.

2) Install the adapter board software on your computer

by running the PicoRegMapToolSetupVxxx.EXE

program inside the temporary folder.

3) Verify that all jumpers are in their default positions,

as shown in Table 1.

4) Connect the Pmod port of the MAXPICO2PMB board

to the Pmod connector on the EV kit or demo board

under evaluation.

5) Connect the USB A to Micro-B cable to the PC and

to the MAXPICO2PMB adapter board’s USB Micro-B

port located at U1. LED D2 on the MAX32625PICO

microcontroller flashes blue.

6) Run the previously installed GUI program.

7) If connection between the PC and the adapter board

is successfully established, the status bar at the bot-

tom displays

8) The adapter board is now ready for additional evalu-

ations with a specific EV kit or demo board.

Figure 1. The Status of the GUI Shows I2C Slave Not Found Ready for Further Evaluations