LP8733 datasheet(35/85 Pages) TI

35 / 85 page

Time

Voltage

VOUTx

300 mV

Time

Current

ILIMx

INT_LDO(LDOx_ILIM_INT)

20Ps

nINT

LDO_STAT(LDOx_STAT)

Resistive

pull-down

Regulator disabled

by digital

Host clearing the interrupt by writing to flags

New startup if

enable is valid

1ms

INT_LDO(LDOx_SC_INT)

LP8733-Q1

www.ti.com

SNVSB64 – SEPTEMBER 2018

Submit Documentation Feedback

Figure 21. LDO Regulator Overload Situation

7.3.8.2.2

Thermal Warning

The LP8733xx-Q1 device includes a protection feature against overtemperature by setting an interrupt for host

processor. The threshold level of the thermal warning is selected with TDIE_WARN_LEVEL bit in CONFIG

If the LP8733xx-Q1 device temperature increases above thermal warning level the device sets TDIE_WARN_INT

bit in INT_TOP_1 register and pulls the nINT pin low. The status of the thermal warning can be read from

TDIE_WARN_STAT bit in TOP_STAT register, and the interrupt is cleared by writing 1 to TDIE_WARN_INT bit.

The thermal warning interrupt can be masked by setting TDIE_WARN_MASK bit in TOP_MASK_1 register to 1.

7.3.8.3 Protection (Regulator Disable)

If the regulator is disabled because of protection or fault (short-circuit protection, overload protection, thermal

shutdown, input overvoltage protection, or UVLO), the output power FETs are set to high-impedance mode, and

the output pulldown resistor is enabled (if enabled with BUCKx_RDIS_EN bit in BUCKx_CTRL_1 register and

LDOx_RDIS_EN bit in LDOx_CTRL register). The turnoff time of the output voltage is defined by the output

capacitance, load current, and the resistance of the integrated pull-down resistor. The pulldown resistors are

active as long as VANA voltage is above approximately a 1.2-V level.

7.3.8.3.1

Short-Circuit and Overload Protection

A short-circuit protection feature allows the LP8733xx-Q1 to protect itself and external components against short

circuit at the output or against overload during start-up. For buck and LDO regulators the fault thresholds are

about 350 mV (buck) and 300 mV (LDO), and the protection is triggered and the regulator is disabled if the

output voltage is below the threshold level 1 ms after the regulator is enabled.

In a similar way the overload situation is protected during normal operation. If the output voltage falls below 0.35

V and 0.3 V and remains below the threshold level for 1 ms the regulator is disabled.

LP8733 bảng dữ liệu(PDF) 35 Page - Texas Instruments

LP8733 bảng dữ liệu(HTML) 35 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85

bảng dữ liệu tải về

Link URL