Epoxy Potting Compound/Adhesive

DP270 Clear and Black

- 5 -

Adhesive*

6mm Nozzle

gms/minute

10mm Nozzle

gms/minute

3

M™ Scotch-Weld™ Epoxy Potting

Compound/Adhesive DP270 Black

38.2

148.8

3M™ EPX

Pneumatic Applicator

Delivery Rates

200 ml Applicator – Maximum Pressure 58 psi

48.5/50 ml Applicator – Maximum Pressure 50 psi

Adhesive*

1/4 in. Nozzle

gms/minute

3

M™ Scotch-Weld™ Epoxy Potting

Compound/Adhesive DP270 Clear

Scotch-Weld epoxy potting

compound/adhesive DP270 Black

75.6

68.6

*Tests were run at a temperature of 70°F ± 2°F (21°C ± 1°C) and at maximum applicator pressure.

Handling/Curing

Information

Directions for Use

1. For high strength structural bonds, paint, oxide films, oils, dust, mold release

agents and all other surface contaminants must be completely removed. However,

the amount of surface preparation directly depends on the required bond strength

and the environmental aging resistance desired by user. For specific surface

preparations on common substrates, see the section on surface preparation.

2. These products consist of two parts.

Mixing

For Duo-Pak Cartridges

3M™ Scotch-Weld™ epoxy potting compound/adhesive DP270 Clear and Black

are supplied in a dual syringe plastic duo-pak cartridge as part of the 3M™ EPX

Applicator systems. To use, simply insert the duo-pak cartridge into the EPX

applicator and start the plunger into the cylinders using light pressure on the

trigger. Next, remove the duo-pak cartridge cap and expel a small amount of

adhesive to be sure both sides of the duo-pak cartridge are flowing evenly and

freely. If mixing of Part A and Part B is desired, attach the EPX applicator mixing

nozzle to the duo-pak cartridge and begin dispensing the adhesive. For hand

mixing, expel the desired amount of material and mix thoroughly to obtain a

uniform color.

For Bulk Containers

Mix thoroughly by weight or volume in the proportions specified in the typical

uncured properties section to obtain a uniform color.