TDSUSBF datasheet(8/46 Pages) TEKTRONIX

8 / 46 page

TekExpress® SATA Automated Compliance Test Software – Complete support for

SATA Gen1/2/3 defined test suites for transmitters and receivers. Reduce your

compliance test time by approximately 70% with simple, efficient automation of all

required test suites with TekExpress® software. Also included is auto-recognition of all

required test equipment, precise DUT/Host control, and one-button testing.

TekExpress® PCI Express Gen 1/2/3 Automated Test Software (Option PCE3) -

Provides the most comprehensive solution for PCI Express Gen 1/2/3 transmitter

compliance testing as well as debug and validation of PCI Express devices against the

PCI-SIG specifications. The application automates selection of appropriate fixture de-

embed and reference channel emulation filters and measurement selections based on

test type, device data rate, transmitter equalization, link width, and selected probes. In

addition, the Option PCE3 application includes a TekExpress compliance automation

solution that integrates the PCI-SIG's Sigtest test software with Tektronix' DPOJET-

based PCI Express Jitter and Eye Diagram & SDLA Serial Data Link Analysis Visualizer

analysis tools for debug. Results are presented in a comprehensive HTML format for

engineering test documentation.

TekExpress® MHL Advanced Analysis and Compliance Software (Option MHD) -

Provides the most comprehensive solution for MHL 1.0/2.0/1.3/2.1 compliance testing as

well as debug and validation of MHL devices against the latest MHL specifications. The

application automates Transmitter, Sink and Dongle Electrical tests. Results are

presented in a comprehensive HTML format for engineering test documentation

Custom filter and de-embed capability

Create your own filters or use the filters provided as standard with the

MSO/DPO70000 Series to enhance your ability to isolate or remove a

component of your signal (noise or specific harmonics of the signal). These

customizable FIR filters can be used to implement signal-processing

techniques, such as removing signal pre-emphasis or minimizing the

effects of fixtures and cables connected to the device under test. Using the

optional Serial Data Link Analysis Visualizer (SDLA64) application, you can

gain further insight into serial data links with the capability to emulate the

serial data channel from its S-parameters, remove reflections, cross-

coupling, and loss caused by fixtures, cables, or probes, and open closed

eyes caused by channel effects using receiver equalization techniques,

such as CTLE, DFE, FFE. IBIS-AMI models for silicon-specific receiver

equalization can be used to observe on-chip behavior.

Datasheet

8 www.tek.com

TDSUSBF bảng dữ liệu(PDF) 8 Page - TEKTRONIX, INC.