DPO4USB datasheet(14/46 Pages) TEKTRONIX

14 / 46 page

P6616 MSO probe – This unique probe design offers two eight-channel

pods. Each channel ends with a probe tip featuring a recessed ground for

simplified connection to the device under test. The coax on the first channel

of each pod is colored blue making it easy to identify. The common ground

uses an automotive-style connector making it easy to create custom

grounds for connecting to the device under test. When connecting to

square pins, the P6616 has an adapter that attaches to the probe head

extending the probe ground flush with the probe tip so you can attach to a

header. The P6616 offers outstanding electrical characteristics, having only

3 pF of capacitive loading, a 100 kΩ input resistance, and is capable of

acquiring toggle rates >500 MHz and pulses as short as 1 ns in duration.

The P6616 MSO probe offers two eight-channel pods to simplify connecting to your

device.

5 – Serial Protocol Triggering and Analysis (optional)

On a serial bus, a single signal often includes address, control, data, and

clock information. This can make isolating events of interest difficult.

Automatic trigger, decode, and search on bus events and conditions gives

you a robust set of tools for debugging serial buses. The optional serial

protocol triggering and analysis functionality is offered free for a 30-day trial

period. This free trial period starts automatically when the instrument is

powered on for the first time.

Triggering on a specific OUT Token packet on a USB full-speed serial bus. The yellow

waveform is the D+ and the blue waveform is the D-. A bus waveform provides decoded

packet content including Start, Sync, PID, Address, End Point, CRC, Data values, and

Stop.

Serial triggering – Trigger on packet content such as start of packet,

specific addresses, specific data content, unique identifiers, etc. on popular

serial interfaces such as I2C, SPI, USB 2.0, Ethernet, CAN, CAN FD (ISO

and non-ISO), LIN, FlexRay, RS-232/422/485/ UART, MIL-STD-1553,

ARINC-429, and I2S/LJ/RJ/TDM.

Bus display – Provides a higher-level, combined view of the individual

signals (clock, data, chip enable, etc.) that make up your bus, making it

easy to identify where packets begin and end and identifying sub-packet

components such as address, data, identifier, CRC, etc.

Bus decoding – Tired of having to visually inspect the waveform to count

clocks, determine if each bit is a 1 or a 0, combine bits into bytes, and

determine the hex value? Let the oscilloscope do it for you! Once you've set

up a bus, the MSO/DPO4000C Series will decode each packet on the bus,

and display the value in hex, binary, decimal (USB, Ethernet, MIL-

STD-1553, ARINC-429, CAN, CAN FD, LIN, and FlexRay only), signed

decimal (I 2S/LJ/RJ/TDM only), or ASCII (USB, Ethernet, and

RS-232/422/485/UART only) in the bus waveform.

Datasheet

14 www.tek.com

DPO4USB bảng dữ liệu(PDF) 14 Page - TEKTRONIX, INC.

DPO4USB bảng dữ liệu(HTML) 14 Page - TEKTRONIX, INC.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

bảng dữ liệu tải về

Link URL