TRANSMITTER

RECEIVER

Single-core fiber

Multi-core fiber

Wiring Diagrams

4

1

3

2

10-30V dc

CH1

CH2

+

–

Load

Load

Figure 2. Channel 1 as a Push-Pull discrete output, Channel 2 as PNP

discrete output

4

1

3

2

10–30 V dc

CH1

CH2

+

–

Load

Remote

Input

Figure 3. Channel 1 as a Push-Pull discrete output, Channel 2 as

remote input

Key

1 = Brown

2 = White

3 = Blue

4 = Black

Note: Open lead wires must be connected to a terminal block.

Note: The Channel 2 wire function is user-selectable. The default is independent Light Operate (LO) PNP output. See the Remote Input

section for details regarding use as remote input or the Sync Master/Slave section for use as a synchronization output.

Top Panel Interface

Opening the dust cover provides access to the top panel interface. The top panel interface consists of the RUN/PRG/ADJ mode

switch, CH1/CH2 switch, +/SET/- rocker button, dual red/green digital displays, and output LED.

RUN/PRG/ADJ Mode Switch

The RUN/PRG/ADJ mode switch puts the sensor in RUN, PRG (Program), or ADJ (Adjust) mode.

•

RUN mode allows the sensor to operate normally and prevents unintentional programming changes via

the +/SET/- rocker button.

•

PRG mode allows the sensor to be programmed through the display-driven programming menu (see

Program Mode).

•

ADJ mode allows the user to perform Expert TEACH/SET methods and Manual Adjust (see Adjust

Mode).

CH1/CH2 Switch (Dual Output Mode)

The CH1/CH2 switch selects which output's parameters can be accessed and changed in the interface of the

display.

+/SET/- Rocker Button

The +/SET/- rocker button is a 3-way button. The +/- positions are engaged by rocking the button left/right. The

SET position is engaged by clicking down the button while the rocker is in the middle position. All three button

positions are used during PRG mode to navigate the display-driven programming menu. During ADJ mode,

SET is used to perform TEACH/SET methods and +/- are used to manually adjust the threshold(s). The rocker

button is disabled during RUN mode, except when using Window SET.

Red/Green Digital Displays

During RUN and ADJ modes, the Red display shows the signal level, and the Green display shows the

threshold or the total counts. During PRG mode, both displays are used to navigate the display-driven

programming menu.

P/N 193601 Rev. B

www.bannerengineering.com - Tel: + 1 888 373 6767

3