Mount to the Accessory Bracket (SA-DIN-BRACKET)

1. Position the DF-G2 in the SA-DIN-BRACKET.

2. Insert the supplied M3 screws.

3. Tighten the screws.

Remove from a DIN rail

1. Push the DF-G2 up on the DIN rail (1).

2. Pivot the DF-G2 away from the DIN rail and remove it

(2).

Installing the Fibers

Follow these steps to install glass or plastic fibers.

1. Open the dust cover.

2. Move the fiber clamp forward to unlock it.

3. Insert the fiber(s) into the fiber port(s) until they stop.

4. Move the fiber clamp backward to lock the fiber(s).

5. Close the dust cover.

Fiber Emitter

Port

Fiber Receiver

Fiber Clamp

Port

Move forward

to release the

fibers

Note: For optimum performance of IR models, if applicable, glass fibers must be used.

Fiber Adapters

Note: If a thin fiber with less than 2.2 mm outer diameter is used, install the fiber adapter provided with the fiber

assembly to ensure a reliable fit in the fiber holder. Align the fibers to the end of the adaptors. Banner includes

the adapters with all fiber assemblies.

TO

FIBERS

TO

SENSOR

Fiber Outer Diameter (mm)

Adapter Color

Ø 1.0

Black

Ø 1.3

Red

Ø 2.2

No adapter needed

When connecting coaxial-type fiber assemblies to the amplifier, install the single-core (center) fiber to the Transmitter port, and the

multi-core (outer) fiber to the Receiver port. This will result in the most reliable detection.

2

www.bannerengineering.com - Tel: + 1 888 373 6767

P/N 193601 Rev. B