Banner model 45SD plug-in bus cards enable a Banner Q45X Series sensor to

establish a logical relationship between the sensor's output and other compat-

expansion cards for Q45X sensors which includes models for use on AS-

Use of a 45SD bus expansion card turns the Q45X into a "smart" sensor which

can be connected to an SDS bus network using a simple "dumb drop" junction

box or a "T" connector. Plugging a bus expansion card into a Q45X Series

sensor automatically converts the basic sensor outputs to a pair of datacom

sensors without bus cards (i. e. "dumb sensors") may also be added to any bus

system, via a "smart drop" junction box. Basic Q45X sensors (without bus

expansion cards) interface directly to PLC dc inputs. See the functional

schematics on the other side of

this data sheet. The block dia-

gram at the right illustrates how

"smart" and "dumb" Q45X Series

sensors can be mixed together on

the same bus network.

On a Q45X Series sensor with a

45SD1 expansion card installed, a

green LED lights to indicate

POWER ON, and a red LED indi-

cates received light signal strength

NOTE: The yellow sensor LED is

disabled when a bus network card is installed.

Emitter model Q45X6EQ has green indicator only.

SDS™ is a trademark of Honeywell Micro Switch Division

Printed in USA

P/N 39669D6B

Data

Input

Input

Input

PLC

Q45X

Q45X

Q45X

Q45X

Q45X

Q45X

Q45X

Q45X

Q45X

Q45X

Q45X

Q45X

"Dumb" Sensors

(x4)

"Smart" Sensors

(x4)

Smart

Drop

Dumb

Drop

"T"

"Dumb" Sensors

(x3)

"Smart" sensor

Connector

Bus

Supply voltage and current:

The sensor is powered by the bus network (11 to 25V dc; 60

mA combined current for Q45X sensor and 45SD card).

Output configuration: Standard CAN transceiver, non-isolated.

Circuitry protection: Protected in the event of reverse power

supply polarity and loss of ground (neither condition will harm

the sensor or interrupt other communications on the network).

Sensor response time: 2 milliseconds. The total response time

is the sum of the sensor response time and the network response

time.

seeing it's modulated light source, and pulses at a rate proportional

to the strength of the received light signal. Emitter model Q45X6EQ

has green indicator only.

nect cable, available from Turck, Lumberg, or Brad Harrison

(see page 2).

Operating temperature range: -10 to +70

°C (14 to +158°F)

Relative humidity: 0 to 95%, non-condensing

Model

Part No. Used with Sensor

Communication

45SD1

40060

All Q45XB6 models,

SDS level 4 binary input 1.1.1.5

except emitter

45SDE1 40908

Q45X6EQ emitter

Allows emitters to be powered from the bus;

not communicate