CFA633-RDI-KU datasheet(63/86 Pages) CRYSTAIFONTZ

63 / 86 page

Crystalfontz America, Inc.

Data Sheet Release Date 2012/02/21

www.crystalfontz.com

CFA633-RDI-KU LCD Module (Hardware v2.0 / Firmware u2v1)

February 2012

Page 63



CFA633-RDI-KU without Crystalfontz overlay: The exposed surface of the LCD “glass” is actually the front

polarizer laminated to the glass. The polarizer is made out of a fairly soft plastic and is easily scratched or

damaged. The polarizer will eventually become hazy if you do not take great care when cleaning it. Long contact

with moisture (from condensation or cleaning) may permanently spot or stain the polarizer.

OPERATION



Your circuit should be designed to protect the CFA633-RDI-KU from ESD and power supply transients.



Observe the operating temperature limitations: a minimum of -20°C to a maximum of +70°C with minimal

fluctuation. Operation outside of these limits may shorten life and/or harm display.



At lower temperatures of this range, response time is delayed.



At higher temperatures of this range, display becomes dark. (You may need to adjust the contrast.)



Operate away from dust, moisture, and direct sunlight.

STORAGE AND RECYCLING



Store in an ESD-approved container away from dust, moisture, and direct sunlight.



Observe the storage temperature limitations: -30°C minimum, +80°C maximum with minimal fluctuation. Rapid

temperature changes can cause moisture to form, resulting in permanent damage.



Do not allow weight to be placed on the CFA633-RDI-KU while they are in storage.



Please recycle your outdated Crystalfontz modules at an approved facility.

CFA633-RDI-KU bảng dữ liệu(PDF) 63 Page - Crystalfontz America, Inc.