ADF41513 datasheet(21/30 Pages) AD

21 / 30 page

Data Sheet

ADF41513

Rev. 0 | Page 21 of 30

Bleed Current

set to positive, the optimum bleed current is set by

Bleed Value = floor(90 × (fPFD/100 MHz) × (ICP_CODE + 1)/16) (6)

where:

Bleed Value is the value programmed to Register 6, Bits[31:24].

ICP_CODE is the charge pump current setting programmed to

fPFD is the PFD frequency in MHz.

If the PD polarity is set to negative, the optimum bleed current

is set by

Bleed Value = floor(144 × (fPFD/100 MHz) × (ICP_CODE +1)/16) (7)

Bleed Polarity

Negative polarity is the typical usage.

Bleed Enable

In fractional-N mode of operation, charge pump linearity (and

ultimately phase noise and spurious performance) is improved

if the VCO and reference inputs to the phase detector operate

with a phase offset. This phase offset is implemented by adding

a constant bleed current at the output of the charge pump. Use

bleed only when operating in fractional-N mode, that is,

FRAC1 or FRAC2 not equal to 0. Set Register 6, Bit 22 = 1 to

enable bleed.

INT Mode

modulator (SDM). Setting Register 6, Bit 20 = 1 disables the

SDM so the ADF41513 operates purely in integer N mode.

Disabling the SDM improves phase noise performance and

changes the frequency resolution to fPFD.

ABP

The recommended setting for best figure of merit (FOM) is

narrow (Register 6, Bit 19 = 1).

Loss of Lock (LOL) Enable

If digital lock detect is asserted when loss of lock is enabled and

the reference signal is removed, digital lock detect goes low. Set

Sigma-Delta (SD) Reset

When Register 6, Bit 17 = 0 on a write to Register 0, the SDM is

temporarily set to a fractional value of 0. The SD reset ensures a

consistent fractional spur pattern but also results in a glitch in

the output frequency when the N divider momentarily outputs

FRAC = 0. Remove this glitch by setting Register 6, Bit 17 = 1

(recommended setting).

CP Three-State, PD on

When Register 6, Bit 16 = 1, the charge pump is in three-state

mode but the phase detector (PD) is still operational. Set

Lock Detector Precision (LDP)

sensitivity of the digital lock detector. Lock detect precision

(Register 6, Bits[9:8]) in conjunction with lock detector bias

(Register 9, Bits[31:30]) adjusts the width of the digital lock

detector window. Lock is declared when the PFD reference

arrival time and divided VCO input arrival times consistently

differ by less than the LDP value. Small LDP settings may cause

a false out of lock indication when used with large bleed

currents. See the Lock Detector section for more information.

Phase Detector (PD) Polarity

If using a noninverting loop filter and a VCO with a positive

tuning slope, set the PD polarity to positive.

If using an inverting loop filter and a VCO with a negative

tuning slope, set the PD polarity to positive.

If using a noninverting loop filter and a VCO with a negative

tuning slope, set the PD polarity to negative.

If using an inverting loop filter and a VCO with a positive

tuning slope, set the PD polarity to negative.

Power Down

Set Register 6, Bit 6 = 1 to perform a software power-down. All

circuit blocks are disabled, and the chip enters a low power state

drawing approximately 4 mA. Set Register 6, Bit 6 = 0 to reenable

the chip. Register values are not lost during power-down. Only

one power-down mode is available via Register 11, Bit 31. Set

regulator on during power-down.

Note that Register 12, Bit 20 must be set to 0 when writing this

power-down bit. Otherwise, the chip cannot be powered back

on again by setting Register 6, Bit 6 = 0.

CP Three-State

Setting Register 6, Bit 5 = 1 puts the charge pump into three-

state mode. Set Register 6, Bit 5 = 0 for normal operation.

Counter Reset

Setting Register 6, Bit 4 = 1 holds the N divider and R counter

in reset, which results in no signals being received at the PFD.

ADF41513 bảng dữ liệu(PDF) 21 Page - Analog Devices

ADF41513 bảng dữ liệu(HTML) 21 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

bảng dữ liệu tải về

Link URL