GD25LE80CLIGR datasheet(29/68 Pages) GIGADEVICE

tên linh kiện	GD25LE80CLIGR

Giải thích chi tiết về linh kiện	1.8V Uniform Sector Dual and Quad Serial Flash

PDF	68 Pages

Scroll/Zoom	100%

nhà sản xuất	GIGADEVICE [GigaDevice Semiconductor (Beijing) Inc.]

Trang chủ	http://www.gigadevice.com/

Logo

29 / 68 page

1.8V Uniform Sector

Dual and Quad Serial Flash

GD25LE80C

7.19 Enable/Disable SO to Output RY/BY# (ESRY/DSRY) (70H/80H)

Besides SO pin is used to output data, it also can be used as the status pin of ready/busy. The ESRY command is for

outputting the ready/busy status to SO. When the device is in the process of power on, enter or exit deep power down

mode and erase/program, its status is busy, and the SO output 0. When the device is in the standby mode, the status of

device is ready, then SO output 1. The DSRY command is for resetting ESRY. The ready/busy status will not output to SO

after DSRY issued.

The Enable/Disable SO to Output RY/BY# command sequence:

CS# goes low → sending ESRY command code → CS#

goes high. The command sequence is shown below. CS# must be driven high after the eighth bit of the command code

has been latched in; otherwise the Enable/Disable SO to Output RY/BY# command is not executed.

Figure 22. Enable/Disable SO to Output RY/BY# Diagram

Command

0 1 2 3 4 5 6 7

70H or 80H

CS#

SCLK

GD25LE80CLIGR bảng dữ liệu(PDF) 29 Page - GigaDevice Semiconductor (Beijing) Inc.