MPC7445 datasheet(26/64 Pages) FREESCALE

26 / 64 page

MPC7455 RISC Microprocessor Hardware Specifications, Rev. 4.1

Freescale Semiconductor

Electrical and Thermal Characteristics

Figure 10 shows the L3 bus timing diagrams for the MPC7455 interfaced to MSUG2 SRAMs.

Figure 10. L3 Bus Timing Diagrams for L3 Cache DDR SRAMs

5.2.4.2 L3 Bus AC Specifications for PB2 and Late Write SRAMs

When using PB2 or late write SRAMs at the L3 interface, the parts should be connected as shown in Figure 11.

These SRAMs are synchronous to the MPC7455; one L3_CLKn signal is output to each SRAM to latch address,

control, and write data. Read data is launched by the SRAM synchronous to the delayed L3_CLKn signal it received.

The MPC7455 needs a copy of that delayed clock which launched the SRAM read data to know when the returning

data will be valid. Therefore, L3_ECHO_CLK1 and L3_ECHO_CLK3 must be routed halfway to the SRAMs and

then returned to the MPC7455 inputs L3_ECHO_CLK0 and L3_ECHO_CLK2, respectively. Thus,

L3_ECHO_CLK0 and L3_ECHO_CLK2 are phase-aligned with the input clock received at the SRAMs. The

MPC7455 will latch the incoming data on the rising edge of L3_ECHO_CLK0 and L3_ECHO_CLK2.

L3_ECHO_CLK[0,1,2,3]

L3 Data and Data

VM = Midpoint Voltage (GVDD/2)

Parity Inputs

L3_CLK[0,1]

ADDR, L3CNTL

tL3CHOV

tL3CHOX

L3DATA WRITE

tL3CHOZ

tL3CHDV

tL3CHDX

Outputs

Inputs

tL3CLDV

tL3CLDX

tL3CLDZ

tL3DVEH

tL3DXEL

tL3DVEL

tL3DXEH

Note: tL3DVEH and tL3DVEL as drawn here will be negative numbers, that is, input setup time will be

time after the clock edge.

Note: tL3CHDV and tL3CLDV as drawn here will be negative numbers, that is, output valid time will be

time before the clock edge.

VM = Midpoint Voltage (GVDD/2)

MPC7445 bảng dữ liệu(PDF) 26 Page - Freescale Semiconductor, Inc