| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
MAS6512 bảng dữ liệu(PDF) 14 Page - Micro Analog systems |
|
|
|||||||||||||||||||||||||||||
MAS6512 bảng dữ liệu(HTML) 14 Page - Micro Analog systems |
|
14 / 32 page ![]() DA6512.003 2 December, 2016 14 (32) OSCILLATOR FREQUENCY CONTROL REGISTER (E6/66HEX) Note that the internal clock oscillator frequency has been factory trimmed and the trim value has been stored in the EEPROM (C6/46HEX). It is recommended not to change the factory programmed value! The oscillator frequency control register (E6/66HEX) is for trimming the internal clock oscillator to 200 kHz frequency. This 200 kHz can be measured at the OSC pin. The six LSB bits adjust the oscillator period in 104ns steps. The period increases when the trim value increases. Typically a register value of 28HEX corresponds to the nominal 200 kHz clock oscillator frequency. After finding a suitable trim value it can be stored to the EEPROM (C6/46HEX). Table 7. Oscillator frequency control register (E6/66HEX) Bit Number Bit Name Description Value Function 5-0 OSCF Oscillator frequency control bits 0HEX…3FHEX Oscillator frequency control EEPROM DATA INPUT REGISTER (E8/68HEX) This register can be ignored by user. It is related to internal EEPROM operations and updated automatically during every EEPROM write operation. EEPROM WRITE ENABLE REGISTER (E9/69HEX) The EEPROM is normally write protected. To enable write the EEPROM write enable register should be set to %00000100 (04HEX). To disable write the register should be set to %00000000 (00HEX) which is the register default value after power-on-rest or manual reset by XCLR or reset register. Note: don’t use any other EEPROM write enable register values than these two since other register bits are reserved for internal testing purpose only. Table 8. EEPROM write enable register (E9/69HEX) Bit Number Bit Name Description Value Function 7-3 00000 Reserved. Keep these bits always 0. 2 EWE EEPROM write enable 0 1 EEPROM write disabled EEPROM write enabled 1-0 00 Reserved. Keep these bits always 0. After a power-on-reset and in normal operation the EEPROM write enable register has the default value 00HEX. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |