LM358ADE4 datasheet(19/47 Pages) TI1

19 / 47 page

1.8

3.6

0.5

VOUT

VIN

Vsup+

VOUT

VIN

Vsup-

LM158, LM158A, LM258, LM258A

LM358, LM358A, LM358B, LM2904, LM2904B, LM2904V

www.ti.com

SLOS068V – JUNE 1976 – REVISED SEPTEMBER 2018

Product Folder Links: LM158 LM258 LM258A LM358 LM358A LM358B LM2904 LM2904B LM2904V

Submit Documentation Feedback

10 Application and Implementation

NOTE

Information in the following applications sections is not part of the TI component

specification, and TI does not warrant its accuracy or completeness. TI’s customers are

responsible for determining suitability of components for their purposes. Customers should

validate and test their design implementation to confirm system functionality.

10.1 Application Information

The LMx58 and LM2904 operational amplifiers are useful in a wide range of signal conditioning applications.

Inputs can be powered before VS for flexibility in multiple supply circuits.

10.2 Typical Application

A typical application for an operational amplifier is an inverting amplifier. This amplifier takes a positive voltage on

the input, and makes it a negative voltage of the same magnitude. In the same manner, it also makes negative

voltages positive.

Figure 13. Application Schematic

10.2.1 Design Requirements

The supply voltage must be chosen such that it is larger than the input voltage range and output range. For

instance, this application scales a signal of ±0.5 V to ±1.8 V. Setting the supply at ±12 V is sufficient to

accommodate this application.

10.2.2 Detailed Design Procedure

Determine the gain required by the inverting amplifier using Equation 1 and Equation 2:

(1)

(2)

Once the desired gain is determined, choose a value for RI or RF. [Subscripts should be fixed in the

accompanying figures and equations also.] Choosing a value in the kilohm range is desirable because the

amplifier circuit uses currents in the milliampere range. This ensures the part does not draw too much current.

This example uses 10 kΩ for RI which means 36 kΩ is used for RF. This was determined by Equation 3.

(3)

LM358ADE4 bảng dữ liệu(PDF) 19 Page - Texas Instruments

LM358ADE4 bảng dữ liệu(HTML) 19 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47

bảng dữ liệu tải về

Link URL