MMRF1022HS datasheet(3/16 Pages) NXP

3 / 16 page

MMRF1022HS

RF Device Data

Freescale Semiconductor, Inc.

Electrical Characteristics (TA =25°C unless otherwise noted) (continued)

Characteristic

Symbol

Min

Typ

Max

Unit

Functional Tests (1,2) (In Freescale Doherty Test Fixture, 50 ohm system) VDD =28 Vdc, IDQA = 500 mA, VGSB =0.5 Vdc,

Pout = 63 W Avg., f = 2140 MHz, Single--Carrier W--CDMA, IQ Magnitude Clipping, Input Signal PAR = 9.9 dB @ 0.01% Probability on CCDF.

ACPR measured in 3.84 MHz Channel Bandwidth @ ±5MHz Offset.

Power Gain

Gps

15.6

16.2

18.6

Drain Efficiency

ηD

49.2

51.8

—

Output Peak--to--Average Ratio @ 0.01% Probability on CCDF

PAR

7.2

7.9

—

Adjacent Channel Power Ratio

ACPR

—

–28.8

–27.2

dBc

Load Mismatch (In Freescale Test Fixture, 50 ohm system) IDQA = 500 mA, f = 2140 MHz

VSWR 10:1 at 28 Vdc, 288 W Pulse Output Power

(3 dB Input Overdrive from 363 W Pulse Rated Power)

No Device Degradation

Typical Performance (2) (In Freescale Doherty Test Fixture, 50 ohm system) VDD =28 Vdc, IDQA = 500 mA, VGSB =0.5 Vdc,

2110–2170 MHz Bandwidth

Pout @ 1 dB Compression Point, CW

P1dB

—

301(3)

—

Pout @ 3 dB Compression Point (4)

P3dB

—

400

—

AM/PM

(Maximum value measured at the P3dB compression point across

the 2110–2170 MHz bandwidth)

—

–27

—

VBW Resonance Point

(IMD Third Order Intermodulation Inflection Point)

VBWres

—

100

—

MHz

Gain Flatness in 60 MHz Bandwidth @ Pout =63 W Avg.

—

0.2

—

Gain Variation over Temperature

(–30°Cto+85°C)

∆G

—

0.012

—

dB/°C

Output Power Variation over Temperature

(–30°Cto+85°C) (3)

∆P1dB

—

0.002

—

dB/°C

Table 5. Ordering Information

Device

Tape and Reel Information

Package

MMRF1022HSR5

R5 Suffix = 50 Units, 56 mm Tape Width, 13--inch Reel

NI--1230S--4L2L

1. Part internally matched both on input and output.

2. Measurements made with device in an asymmetrical Doherty configuration.

3. Exceeds recommended operating conditions. See CW operation data in Maximum Ratings table.

4. P3dB = Pavg + 7.0 dB where Pavg is the average output power measured using an unclipped W--CDMA single--carrier input signal where

output PAR is compressed to 7.0 dB @ 0.01% probability on CCDF.

MMRF1022HS bảng dữ liệu(PDF) 3 Page - NXP Semiconductors

MMRF1022HS bảng dữ liệu(HTML) 3 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

bảng dữ liệu tải về

Link URL