3

HMC960LP4E

v01.1212

DC - 100 MHz DUAL DigitAL

VAriAbLe gAin AMpLifier with DriVer

For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824

978-250-3343 tel • 978-250-3373 fax • Order On-line at www.hittite.com

Application Support: apps@hittite.com

Parameter

Conditions

Min.

Typ.

Max.

Units

Full Scale Differential Output

400 Ω Differential Load

100 Ω Differential Load

2

1

Vppd

Vppd

Output Voltage Range

0.5

Vdd - 0.5

V

1

Vdd/2

3

V

Digital I/O

Tested at 30 MHz Operation

Logic Levels

Digital Input Low Level (VIL)

0.4

V

Digital Input High Level (VIH)

1.5

V

Digital Output Low Level (VOL)

0.4

V

Digital Output High Level (VOH)

Vdd - 0.4

V

Supply Related

Digital I/O

Power Supply

Analog & Digital Supplies

4.5

5

5.5

V

Both I/Q channels

70

mA

table 1. electrical Specifications, t

Parameter

Condition

Temperature

+27 °C

Gain Setting

0 dB

Output Signal Level

2 Vppd

Input/Output Common Mode Level

2.5 V

Programmed Impedance

200 Ω per input (400 Ω differential)

Output Load

200 Ω per output (400 Ω differ-

ential)

Supplies

Analog: +5 V, Digital +5 V

Driver Bias Setting

‘10’

Op-Amp Bias Setting

‘01’ (Standard Setting)

table 2. test Conditions

Unless otherwise specified, the following test conditions were used

[1] Sideband Rejection is only measured in dB, but relates to phase/magnitude channel imbalance as follows, for a mismatch of 1 degree phase and

0.1 dB magnitude:

SBR = -10Log[(1+A^2-2Acosx)/(1+A^2+2Acosx)]

where A = 10^(0.1/20) (linear magnitude) and x = 1*pi/180 (radians)

[2] Output common mode voltage range is specified for worst case temperature, supply voltage, and bias settings with 2 Vppd signal amplitude. For

5 V supply and recommended biasing (op-amp bias =1 and driver bias=2), over 3.5 V is typical. See “Output IP3 vs. Common Mode Voltage vs.

[3] Recommend bias setting (op-amp bias =1 and driver bias=2)

[4] Standard deviation = 15 mV

Information furnished by Analog Devices is believed to be accurate and reliable. However, no

responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other

rights of third parties that may result from its use. Specifications subject to change without notice. No

license is granted by implication or otherwise under any patent or patent rights of Analog Devices.

Trademarks and registered trademarks are the property of their respective owners.

For price, delivery, and to place orders: Analog Devices, Inc.,

One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106

Phone: 781-329-4700 • Order online at www.analog.com

Application Support: Phone: 1-800-ANALOG-D