SPBTLE-1S

Regulatory compliance

DocID030445 Rev 3

21/27



Consult the dealer or an experienced radio/TV technician for help

In the case where an OEM seeks the lesser category of a Class A digital device for the final

product, the following statement must be included in the final product manual:

This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to RSS-210 of the IC Rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment is

operated in a commercial environment. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at

his expense.

6.3

SRRC

6.3.1

Modular approval

The SPBTLE-1S module complies with Chinese SRRC certification.

– SRRC CMIIT ID: 2017DJ5956

6.3.2

Labeling instructions

When integrating the SPBTLE-1S into the final product, the OEM must ensure that the FCC

labeling requirements are satisfied. A statement must be included on the exterior of the

final product which indicates the product includes a certified module. The label should state

the following (or similar wording that conveys the same meaning):

This product uses SRRC approved Radio modular. CMIIT ID: 2017DJ5956

6.4

Bluetooth certification

The module with embedded stack and profile has been qualified in accordance with SIG

qualification rules:



Declaration ID: D034470



Qualified design ID: 92838



Product type: End Product



Core spec version: 4.2



Product description: Bluetooth Smart v4.2 module