IRMCS2031

Installing the Software

The ServoDesigner

double-click “IRMCS2031.exe”. It requires the password which also can be found in the same CD-ROM. The

automated procedure installs all necessary software on your PC.

The default location for the installation is

“C:\Program Files\Accelerator”.

Power-On the System

Apply AC115V – AC230Vpower to the system.

Immediately after power-on, the power supply RED LED (located at the bottom left corner of the board) will light

indicating the on-board DC bus has been established. The second LED (surface mount LED located at the top side of

the board) should also start blinking on/off RED.

Getting Started

For quick start with preconfigured parameters, the following motor is supported with a preconfigured motor file.

•

Sanyo Denki motor (400W: type P30B06040DXS00M)

If any other motor is used, reconfiguration is required. Configurable parameters are required to tailor design to various

applications (motor and load). These configurable parameters can be modified via the host register interface (using the

ServoDesigner tool) through the communication interface. In the IRMCS2031 product, a design spreadsheet (Drive

parameters translator) is provided to aid the user for ease of drive start-up.

Using the spreadsheet, the user enters

high-level parameters such as motor nameplate information, maximum application speed, current limit, speed and

current regulator bandwidth.

This high-level user information is translated to engineering parameters (directly used

by the drive). Figure

gives an overview of the commissioning steps. Please refer to the IRMCK203 Application

Developer’s Guide for detailed drive commissioning description.

Drive Parameters Translator

Translate input parameters to drive parameters

Enter high level design parameters

(Motor nameplate, Current limits,

Max speed, overload etc..)

Engineering

parameters

IRMCS2031

ServoDesigner

Input and download drive parameters

Refine drive parameters

User

parameters

Figure 6.

Overview of Drive Commissioning

This document is the property of International Rectifier and may not be copied or distributed without expressed consent.

8