17

Version 1.3 | 25 Sep 2017 | 31007AEN

PixArt Imaging Inc. http://www.pixart.com

All rights reserved. Any portion in this paper shall not be reproduced, copied, or transformed to any other forms without permission.

PAH8002EP-2P Product Datasheet

Low Power Optical Heart Rate Detection Chip

PixArt Imaging Inc.

4.3.2

Schematic Design- Printing Cover Type

Figure 8 Reference Application Circuit–Printing Cover Type

4.4

Design Guidelines

4.4.1

Schematic Design

1. VDDM & VDDIO: 3.3V~3.6V (for 3.3V System)

2. VDDM: 3.3V~3.6V, VDDIO: 1.62V~1.98V (for 1.8V System)

3. It is recommended to separate the power system for VDDM to avoid power interference.

5. VDDD, VDDA28 must have 1µF and VBGP must have 0.1µF capacitor connecting to GND and place closely to 8002.

6. The GND1, GND2 and GND3 must be separated and connected to PCB main GND.

7. INT pin is recommended to be connected to MCU HW INT as data ready INT for power saving.

8. Ensure that the VDDM and VDDIO’s power noise should be under 100mV (with 0.1µF and 10µF capacitor)

10. At power on, VDDM and VDDIO must be powered on at the same time or VDDIO to be powered on before VDDM.

with 8002) to switch on the LDO providing VDDM voltage.

11. At power off, VDDM and VDDIO must be powered off at the same time or VDDM to be powered off first before

VDDIO.