CA 4

SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE

© 2003 TELEDYNE RELAYS

CA\042003\Q1

Series CA

NOTES:

1. To increase the dV/dt characteristic to 200V/µs, use an RC snubber across the output terminals with R =100 and C = 0.01 µF.

2. Control input is compatible with CMOS or open collector TTL (with pull up resistor).

3. For bias voltages above 6V, a series resistor is required. Use a standard resistor value equal to or less than the value found from

Figure 5.

4. Output may temporarily lose blocking capability during and after a surge, until T

5. Input transition should be ≤ 1 msec duration and input drive should be “bounceless contact” type.

6. Unless otherwise noted, the input voltage for functional tests shall be 5 Vdc.

MAXIMUM VOLTAGE DROP VS AMBIENT

TEMPERATURE AT I

L RATED

FIGURE 4

SERIES LIMIT BIAS RESISTOR VS BIAS VOLTAGE

FIGURE 5 (SEE NOTE 3)