C60 datasheet(2/2 Pages) WILLOW

2 / 2 page

C60

SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE

10 TELEDYNE RELAYS

Series C60

CHARACTERISTIC CURVES

WIRING CONFIGURATIONS

MECHANICAL SPECIFICATION

NOTES:

1. Series resistor is required to limit input current to

50 mA maximum.

2. The input current is 10 mA for all tests unless

otherwise specified.

3. The surge current is non-repetitive for a

maximum duration of 20 ms (See Figure 3).

4. Loads may be connected to positive or negative

referenced power supplies. Inductive loads must

be diode suppressed.

5. Continuous load current is rated under the

conditions of still air and mounted on a printed

circuit board.

6. To calculate ON Resistance for a given junction

temperature calculate the new ROn using the

equation shown below:

ROn=R(25°C)x e

0.006(TJ-25°C)

7. Turn on Time can be controlled with input control

current. Calculate a new turn-on time:

tOn=(tSpecification Limit)(10mA/IIn)

8. Load voltage rating should be derated 10% at

-40°C

• Operating Temperature Range: -40°C to 85°C

• Storage Temperature Range: -40°C to 100°C

• Weight: 1 gm. maximum

• Case: 6 pin dual in line, filled epoxy

2DSC60-X0 Rev --

C60 bảng dữ liệu(PDF) 2 Page - Willow Technologies Ltd