L9660 datasheet(36/49 Pages) STMICROELECTRONICS

36 / 49 page

Functional description

L9660

36/49

DocID024714 Rev 2

TX – 0x5901 – ARM Channel 0

RX – 0x5901

TX – 0x5901 – ARM Channel 0

RX – 0x5901

TX – 0x6001 – Firing on Channel 0 is started on if FEN is active

RX – 0x5901

TX – 0x6001 – Command ignored – sequence is not allowed

RX – 0x6001

TX – 0x6001 – Command ignored

RX – 0xD005

Alternatively, if the sequence is broken the response is as in the following example

FENx active

TX – 0x5901 – ARM Channel 0

RX – Based on previous command

TX – 0x2000 – Read of Register Mode 1

RX – 0x5901

TX – 0x6001 – Command ignored – sequence is not allowed

RX – contents of register

TX – 0x6001 – Command ignored – sequence is not allowed

RX – 0xD005

If, for example, channel 0 and 1 bits are set in the Arm command and channel 0 and 2 bits

are set in the fire command then the drivers on channel 0 are activated (assuming FEN

function is active) and there are no effect on channel 2.

During a deployment, any commands directed to the channel that is in deployment are

ignored and the response shall be 0xD009.

Diagnostic commands

Diagnostic Mode

Diagnostic mode main functions are as follows:



Squib short to battery/ground diagnostics



Loop to loop diagnostics



Normal Squib Resistance Diagnostics



High Squib Resistance Diagnostics



High side safing diagnostics



VRESx measurement



LS and HS FET Test

The SPI message definition for MOSI commands and MISO responses in Diagnostic Mode

are defined below.

L9660 bảng dữ liệu(PDF) 36 Page - STMicroelectronics

L9660 bảng dữ liệu(HTML) 36 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

bảng dữ liệu tải về

Link URL