74ACT11010 datasheet(2/5 Pages) TI

2 / 5 page

54ACT11010, 74ACT11010

TRIPLE 3-INPUT POSITIVE-NAND GATES

SCAS018A – D2957, JULY 1987 – REVISED APRIL 1993

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

2–2

absolute maximum ratings over operating free-air temperature range (unless otherwise noted)†

Supply voltage range, VCC

– 0.5 V to 6 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input voltage range, VI (see Note 1)

– 0.5 V to VCC + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output voltage range, VO (see Note 1)

– 0.5 V to VCC + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input clamp current, IIK (VI < 0 or VI > VCC)

± 20 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output clamp current, IOK (VO < 0 or VO > VCC)

± 50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous output current, IO (VO = 0 to VCC)

± 50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous current through VCC or GND

± 100 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Storage temperature range

– 65

°C to 150°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only and

functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not

implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTE 1: The input and output voltage ratings may be exceeded if the input and output current ratings are observed.

recommended operating conditions

54ACT11010

74ACT11010

UNIT

MIN

MAX

MIN

MAX

UNIT

VCC

Supply voltage

4.5

5.5

4.5

5.5

VIH

High-level input voltage

VIL

Low-level input voltage

0.8

Input voltage

VCC

Output voltage

VCC

IOH

High-level output current

–24

IOL

Low-level output current

Dt/Dv

Input transition rise or fall rate

ns / V

Operating free-air temperature

–55

125

–40

°C

electrical characteristics over recommended operating free-air temperature range (unless

otherwise noted)

PARAMETER

TEST CONDITIONS

VCC

TA = 25°C

54ACT11010

74ACT11010

UNIT

PARAMETER

TEST CONDITIONS

VCC

MIN

TYP

MAX

MIN

MAX

MIN

MAX

UNIT

IOH =50 mA

4.5 V

4.4

IOH = – 50 mA

5.5 V

5.4

VOH

IOH =24 mA

4.5 V

3.94

3.7

3.8

VOH

IOH = – 24 mA

5.5 V

4.94

4.7

4.8

IOH = – 50 mA‡

5.5 V

3.85

IOH = – 75 mA‡

5.5 V

3.85

IOL =50 mA

4.5 V

0.1

IOL = 50 mA

5.5 V

0.1

VOL

IOL =24mA

4.5 V

0.36

0.5

0.44

VOL

IOL = 24 mA

5.5 V

0.36

0.5

0.44

IOL = 50 mA‡

5.5 V

1.65

IOL = 75 mA‡

5.5 V

1.65

VI = VCC or GND

5.5 V

± 0.1

± 1

ICC

VI = VCC or GND,

IO = 0

5.5 V

DICC§

One input at 3.4 V,

55 V

DICC§

Other inputs at GND or VCC

5.5 V

0.9

VI = VCC or GND

5 V

3.5

‡ Not more than one output should be tested at a time, and the duration of the test should not exceed 10 ms.

§ This is the increase in supply current for each input that is at one of the specified TTL voltage levels rather than 0 V or VCC.

74ACT11010 bảng dữ liệu(PDF) 2 Page - Texas Instruments

74ACT11010 bảng dữ liệu(HTML) 2 Page - Texas Instruments

Html Pages

1 2 3 4 5

bảng dữ liệu tải về

Link URL