ST7LITE49K2 datasheet(161/245 Pages) STMICROELECTRONICS

tên linh kiện	ST7LITE49K2

Giải thích chi tiết về linh kiện	Communication interfaces

PDF	245 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

161 / 245 page

ST7LITE49K2

On-chip peripherals

161/245

The SPIF bit can be cleared during a second transmission; however, it must be cleared

before the second SPIF bit in order to prevent an Overrun condition (see Section : Overrun

condition (OVR)).

11.6.5

Clock phase and clock polarity

Four possible timing relationships may be chosen by software, using the CPOL and CPHA

bits (See Figure 77).

Note:

The idle state of SCK must correspond to the polarity selected in the SPICSR register (by

pulling up SCK if CPOL = 1 or pulling down SCK if CPOL = 0).

The combination of the CPOL clock polarity and CPHA (clock phase) bits selects the data

capture clock edge.

Figure 77 shows an SPI transfer with the four combinations of the CPHA and CPOL bits.

The diagram may be interpreted as a master or slave timing diagram where the SCK pin, the

MISO pin and the MOSI pin are directly connected between the master and the slave

device.

Note:

If CPOL is changed at the communication byte boundaries, the SPI must be disabled by

resetting the SPE bit.

ST7LITE49K2 bảng dữ liệu(PDF) 161 Page - STMicroelectronics