SPC560D30X datasheet(52/90 Pages) STMICROELECTRONICS

52 / 90 page

Electrical characteristics

SPC560D30x, SPC56040Dx

52/90

Doc ID 16315 Rev 7

4.12

Electromagnetic compatibility (EMC) characteristics

Susceptibility tests are performed on a sample basis during product characterization.

4.12.1

Designing hardened software to avoid noise problems

EMC characterization and optimization are performed at component level with a typical

application environment and simplified MCU software. It should be noted that good EMC

performance is highly dependent on the user application and the software in particular.

Therefore it is recommended that the user apply EMC software optimization and

prequalification tests in relation with the EMC level requested for his application.

●

Software recommendations

The software flowchart must include the management of

runaway conditions such as:

–

Corrupted program counter

–

Unexpected reset

–

Critical data corruption (control registers...)

●

Prequalification trials

Most of the common failures (unexpected reset and program

counter corruption) can be reproduced by manually forcing a low state on the reset pin

or the oscillator pins for 1 second.

To complete these trials, ESD stress can be applied directly on the device. When

unexpected behavior is detected, the software can be hardened to prevent

unrecoverable errors occurring (see the application note Software Techniques For

Improving Microcontroller EMC Performance (AN1015)).

4.12.2

Electromagnetic interference (EMI)

The product is monitored in terms of emission based on a typical application. This emission

test conforms to the IEC 61967-1 standard, which specifies the general conditions for EMI

measurements.

tFLALPEXIT

Delay for flash module to exit low-power

mode(2)

Code flash

—

0.5

µs

tFLAPDEXIT

Delay for flash module to exit power-down

mode

Code flash

—

µs

Data flash

—

30(3)

µs

tFLALPENTRY

Delay for flash module to enter low-power

mode

Code flash

—

0.5

µs

tFLAPDENTRY

Delay for flash module to enter power-

down mode

Code flash

—

1.5

µs

Data flash

—

4(3)

µs

VDD = 3.3 V ± 10% / 5.0 V ± 10%, TA = 40 to 125 °C, unless otherwise specified

Data flash does not support low-power mode

If code flash is already switched-on.

Table 32.

Start-up time/Switch-off time (continued)

Symbol

Parameter

Conditions(1)

Value

Unit

Min

Typ

Max

SPC560D30X bảng dữ liệu(PDF) 52 Page - STMicroelectronics

SPC560D30X bảng dữ liệu(HTML) 52 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90

bảng dữ liệu tải về

Link URL