Contents

SPC56EL70xx, SPC564L70xx

2/15

DocID023968 Rev 4

Contents

1

Functional problems . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

1.1

e3320: Flash: single bit correction status is not available in the Error

Correction Status Module (ECSM) and in the Fault Collection and Control

Unit (FCCU) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

1.2

e3697: e200z: Exceptions generated on speculative prefetch . . . . . . . . . 5

1.3

e4016: ADC: Presampling on channels 9, 10, 15 leads to incorrect results

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

1.4

e4168: ADC: "Abort switch" aborts the ongoing injected channel as well as

the upcoming normal channel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

1.5

e4186: ADC: triggering an ABORT or ABORTCHAIN before the conversion

starts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

1.6

e4334: MC_RGM: Device stays in reset state on external reset assertion

7

1.7

e4340: LINFlexD: Buffer overrun can not be detected in UART Rx FIFO

mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

1.8

e0063: MC_ME: ME_PCTL18 not protected by the register protection . . . 8

1.9

e6726: NPC: MCKO clock may be gated one clock period early when MCKO

frequency is programmed as SYS_CLK/8.and gating is enabled . . . . . . . 8

1.10

e6967: eDMA: Possible misbehavior of a preempted channel when using

continuous link mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

1.11

e7120: NZxC3: DQTAG implemented as variable length field in DQM

message . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

1.12

e7274: LINFlexD: Consecutive headers received by LIN Slave triggers error

interrupt . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

1.13

e7322: FlexCAN: Bus Off Interrupt bit is erroneously asserted when soft

reset is performed while . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

1.14

e7352: DSPI: reserved bits in slave CTAR are writable . . . . . . . . . . . . . . 10

1.15

e7394: MC_ME: Incorrect mode may be entered on low-power mode exit

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11

1.16

ERR007877: FlexPWM: do not enable the fault filter . . . . . . . . . . . . . . . . .11

1.17

ERR008070: SWG: GPIO[55] functionality is not available unless the SWG

is powered down . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11

Appendix A

Additional information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

A.1

Reference document . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

A.2

Acronyms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12