UM0382 datasheet(21/32 Pages) STMICROELECTRONICS

21 / 32 page

UM0382

Data acquisition quick start

21/32

Data acquisition quick start

This section describes the basic steps that have to be performed to acquire the acceleration

data from the EK3LV02DQ:

connect the EK3L02DL to the USB port;

start the EK3LV02DQ GUI;

select the Virtual COM port and then click on the “Connect” button (Figure 9, ref2);

select the destination file in which the acceleration data must be saved by clicking onto

“Setup” (Figure 14, ref1) and “Destination File” (Figure 14, ref7) buttons;

optionally select the desired decimation factor, Horizontal and Vertical gain and then

click on the “OK” button (Figure 14, ref8);

click on “Plot Data” or “Show Data” (Figure 9, ref6) to activate the corresponding Data

Display window (Figure 15);

click on “Browsing” button to activate the function of map browsing (Figure 9, ref6) and

then load the desired image by clicking on “Load Image” button;

click on “START” (”STOP”) button to activate (stop) the collection of data from the

sensor, their saving onto file and plotting on the screen;

to close the application click on Disconnect and then click on Exit.

UM0382 bảng dữ liệu(PDF) 21 Page - STMicroelectronics