DocID025667 Rev 3

13/18

STGIPS10K60A2

Application information

18

4.1

Recommendations

•

Input signal HIN,LIN are active-high logic. A 500 k

Ω (typ.) pull down resistor is built-in

for each high side input. If an external RC filter is used, for noise immunity, pay

attention to the variation of the input signal level.

•

To prevent the input signals oscillation, the wiring of each input should be as short as

possible.

•

By integrating an application specific type HVIC inside the module, direct coupling to

MCU terminals without any opto-coupler is possible.

•

Each capacitor should be located as nearby the pins of IPM as possible.

•

Low inductance shunt resistors should be used for phase leg current sensing.

•

Electrolytic bus capacitors should be mounted as close to the module bus terminals as

possible. Additional high frequency ceramic capacitor mounted close to the module

pins will further improve performance.

For further details, refer to AN3338.

Table 12. Recommended operating conditions

Symbol

Parameter

Conditions

Min.

Typ.

Max.

Unit

Supply Voltage

Applied between P-Nu, Nv, Nw

300

400

V

Control supply voltage

12

15

17

V

High side bias voltage

i = U, V, W

11.5

17

V

Blanking time to

prevent Arm-short

For each input signal

1

µs

PWM input signal

20

kHz

Case operation

temperature

100

°C