HLMP-EJ37-R0PDD datasheet(2/4 Pages) AVAGO

2 / 4 page

Absolute Maximum Rating (TA=25°C)

Device Selection Guide

Tolerance for luminous intensity is ±15%.

Tolerance for color bin limit is ± 0.5 nm

Notes:

1. The luminous intensity is measured on the mechanical axis of

the lamp package.

3. The optical axis is closely aligned with the package mechanical

axis.

4. The dominant wavelength, ld, is derived from the CIE

Chromaticity Diagram and represents the color of the lamp.

θ1/2 is the off axis angle where the luminous intensity is one

half the on-axis intensity.

Note:

1. Derate linearly as shown in fugure 4.

2. For long terms performance with minimum light output

degration, drive currents between 10mA and 30 mA are

recommended. For more information on recommended drive

condition, please refer to Application Brief I-024.

3. Operating at current below 1mA is not recommended. Please

contact your local representative for further information.

Part Number

Dominant

Wavelength

Range (nm)

Luminous

Intensity, Min

(mcd at 20mA)

HLMP-EJ37-R0PDD

605.5 -612.5

1500

Parameters

Value

DC forward current[1]

50 mA

Peak pulsed forward current[2]

100 mA

Average forward current

30 mA

Reverse voltage (Ir = 100 mA)

5 V

LED junction temperature

130oC

Power Dissipation

120mW

Operating temperature

-40oC to +100oC

Storage temperature

-40oC to +120oC

Through the wave soldering

temperature

250oC for 3 seconds

Package Dimensions

Notes :

1. All dimensions are in milimetres (inches).

2. Leads are mild steel, solder dipped.

3. Tapers shown at top of leads (bottom of lamp package) indicate

an epoxy meniscus that may extend about 1mm (0.040in.) down

the leads.

4. Recommended PC board hole diameters = 0.965/0.889 (0.038/

0.035)

5. For dome heights above lead standoff seating plane, d = 11.96

± 0.25 (0.471 ± 0.010).

1.14 ± 0.20

(0.045 ± 0.008)

5.80 ± 0.20

(0.228 ± 0.008)

5.00

± 0.20

(0.197 ± 0.008)

31.60

(1.244)

MIN.

0.70 (0.028)

MAX.

1.00

(0.039)

MIN.

8.71 ± 0.20

(0.343 ±0.008)

2.54 ± 0.38

(0.100 ± 0.015)

0.50 ± 0.10

(0.020 ± 0.004)

SQ. TYP.

CATHODE

LEAD

CATHODE

FLAT

1.50 ± 0.15

(0.059 ± 0.006)

HLMP-EJ37-R0PDD bảng dữ liệu(PDF) 2 Page - AVAGO TECHNOLOGIES LIMITED

HLMP-EJ37-R0PDD bảng dữ liệu(HTML) 2 Page - AVAGO TECHNOLOGIES LIMITED

Html Pages

1 2 3 4

bảng dữ liệu tải về

Link URL