74ACT11377DBLE datasheet(2/5 Pages) TI

2 / 5 page

74ACT11377

OCTAL D-TYPE FLIP-FLOP

WITH CLOCK ENABLE

SCAS129 – D3450, MARCH 1990 – REVISED APRIL 1993

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

2–2

logic symbol†

logic diagram (positive logic)

CLKEN

CLK

Six Identical

Stages

Not Shown

CLK

CLKEN

1C2

† This symbol is in accordance with ANSI/IEEE Std 91-1984

and IEC Publication 617-12.

absolute maximum ratings over operating free-air temperature range (unless otherwise noted)‡

Input voltage range, VI (see Note 1)

– 0.5 V to VCC + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output voltage range, VO (see Note 1)

– 0.5 V to VCC + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input clamp current, IIK (VI < 0 or VI > VCC)

± 20 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output clamp current, IOK (VO < 0 or VO > VCC)

± 50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous output current, IO (VO = 0 to VCC)

± 50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous current through VCC or GND

± 200 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Storage temperature range

– 65

°C to 150°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

} Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only and

functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not

implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTE 1: The input and output voltage ratings may be exceeded if the input and output current ratings are observed.

recommended operating conditions

MIN

MAX

UNIT

VCC

Supply voltage

4.5

5.5

VIH

High-level input voltage

VIL

Low-level input voltage

0.8

Input voltage

VCC

Output voltage

VCC

IOH

High-level output current

–24

IOL

Low-level output current

Dt/Dv

Input transition rise or fall rate

ns / V

Operating free-air temperature

–40

°C

74ACT11377DBLE bảng dữ liệu(PDF) 2 Page - Texas Instruments

74ACT11377DBLE bảng dữ liệu(HTML) 2 Page - Texas Instruments

Html Pages

1 2 3 4 5

bảng dữ liệu tải về

Link URL