| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
CC3220MODSM2MOBR/T bảng dữ liệu(PDF) 13 Page - Texas Instruments |
|
|
|||||||||||||||||||||||||||||
CC3220MODSM2MOBR/T bảng dữ liệu(HTML) 13 Page - Texas Instruments |
|
13 / 82 page ![]() 13 CC3220MOD www.ti.com SWRS206 – MARCH 2017 Submit Documentation Feedback Product Folder Links: CC3220MOD Terminal Configuration and Functions Copyright © 2017, Texas Instruments Incorporated 4.4 Pin Attributes and Pin Multiplexing The module makes extensive use of pin multiplexing to accommodate the large number of peripheral functions in the smallest possible package. To achieve this configuration, pin multiplexing is controlled using a combination of hardware configuration (at module reset) and register control. The board and software designers are responsible for the proper pin multiplexing configuration. Hardware does not ensure that the proper pin multiplexing options are selected for the peripherals or interface mode used. Table 4-3 describes the general pin attributes and presents an overview of pin multiplexing. All pin multiplexing options are configurable using the pin mux registers. The following special considerations apply: • All I/Os support drive strengths of 2, 4, and 6 mA. Drive strength is individually configurable for each pin. • All I/Os support 10-μA pullup and pulldown resistors. • By default, all I/Os float in the Hibernate state. However, the default state can be changed by SW. • All digital I/Os are non fail-safe. NOTE If an external device drives a positive voltage to the signal pads and the CC3220MODx device is not powered, DC is drawn from the other device. If the drive strength of the external device is adequate, an unintentional wakeup and boot of the CC3220MODx device can occur. To prevent current draw, TI recommends any one of the following conditions: • All devices interfaced to the CC3220MODx device must be powered from the same power rail as the chip. • Use level shifters between the device and any external devices fed from other independent rails. • The nRESET pin of the CC3220MODx device must be held low until the VBAT supply to the device is driven and stable. • All GPIO pins default to high impedence unless programmed by the MCU. The bootloader sets the TDI, TDO, TCK, TMS, and Flash_SPI pins to mode 1. All the other pins are left in the Hi-Z state. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |