EMC Immunity and Radiated Emissions Tests

Radiated Emissions, FCC Class B, 6 dB margin

IEC 1000-4-2 ESD Test Method

Performance Criteria B, Level 2

IEC 1000-4-3 Radiated Immunity

Performance Criteria A, Level 3 (10V/m)

IEC 10004-4 EFT Test Method

Performance Criteria B, Level 3 (at I/O port)

Criteria A: The system shall continue to operate normally. The EUT shall be deemed to have passed the immunity tests if no bit

errors occur when receiving data over the cable. Changes of state, reset condition, unrecoverable jab condition,

blocked network, or loss of packets is unacceptable.

Criteria B: The system shall operate normally with no data errors through the loop after the test. During the test, data errors,

aborted frames and collisions are acceptable. No change of operating state such as system reset or unrecoverable

condition is permitted during or after the test.

Product Qualification Test Outline

V. Subgroup V (6 pieces)

Thermal shock

Per MIL-STD-202, Method 107, Condition A-1, except

temperature range shall be -20° C to +125° C, 25 cycles

Vibration

Per MIL-STD-202, Method 204D, Condition D, 20G

peak acceleration, 10 Hz to 2 KHz and return to 10 Hz

traversed in 6 minutes

Shock

Per MIL-STD-202, Method 213B, Condition J, 30G,

11msec shock, 3 shocks in each direction along

mutually perpendicular axes

VI. Subgroup VI (6 pieces)

Life Test

Per MIL-STD-202, Method 108, 1000 hours at a

temperature of 75° C

VII. Subgroup VII (8 pieces)

Humidity Test

Humidity test @ 40° C, and 90% humidity (4 pieces)

VIII. Subgroup VIII (6 pieces)

Electrostatic Discharge, ESD Classification

The ESD classification to be derived from ESD

testing per IEC801-2, EN50082-1, Criteria B

NOTE: There shall be 0 (zero) rejects allowable for

each of the subgroups.

I. Subgroup I (all devices - 40 pieces)

- Jitter (total peak-to-peak)

- CMI Mask Test (rise time, fall time, and amplitude)

- Jitter (total peak-to-peak)

Total power supply current

II. Subgroup II (4 pieces)

External visual inspection

Resistance to solvents per MIL-STD-202, Method 215H

- 1 part isopropyl alcohol, 3 parts mineral spirits

- Trichloroethane

- Terpene defluxer with a minimum of 90% d-limonene

and 10% surfactant

- 42 parts water, 1 part propylene glycol monomethyl

ether, 1 part monoethanolamine

Terminal strength per MIL-STD-883, Method 2004.5

- Lead tension

III. Subgroup III (4 pieces)

Solderability

Per MIL-STD-202, Method 208, with a 4-hour

steam age

IV. Subgroup IV (6 pieces)

Resistance to soldering heat

Hand solder (2 pieces), solder dip temperature of 430

±5° C for 3 seconds maximum

Vapor phase reflow (4 pieces) for a period of 60

seconds at a temperature of 215 +5/-0° C

TWO PEARL BUCK COURT

BRISTOL, PA 19007-6812

TEL 215-781-6400

FAX 215-781-6403

www.pulsespecialty.com

Fibre Channel Module — 3