LMC6041 datasheet(7/12 Pages) NSC

7 / 12 page

Typical Performance Characteristics V

S = ± 7.5V, TA = 25˚C unless otherwise

specified (Continued)

Applications Hints

AMPLIFIER TOPOLOGY

The LMC6041 incorporates a novel op-amp design topology

that enables it to maintain rail-to-rail output swing even when

driving a large load. Instead of relying on a push-pull unity

gain output buffer stage, the output stage is taken directly

from the internal integrator, which provides both low output

impedance and large gain. Special feed-forward compensa-

tion design techniques are incorporated to maintain stability

over a wider range of operating conditions than traditional

micropower op-amps. These features make the LMC6041

both easier to design with, and provide higher speed than

products typically found in this ultra-low power class.

COMPENSATING FOR INPUT CAPACITANCE

It is quite common to use large values of feedback resis-

tance with amplifiers with ultra-low input current, like the

LMC6041.

Although the LMC6041 is highly stable over a wide range of

operating conditions, certain precautions must be met to

achieve the desired pulse response when a large feedback

resistor is used. Large feedback resistors and even small

values of input capacitance, due to transducers, photo-

diodes, and circuits board parasitics, reduce phase margins.

When high input impedance are demanded, guarding of the

LMC6041 is suggested. Guarding input lines will not only re-

duce leakage, but lowers stray input capacitance as well.

(See Printed-Circuit-Board Layout for High Impedance

Work.)

The effect of input capacitance can be compensated for by

adding a capacitor. Adding a capacitor, C

f, around the feed-

back resistor (as in

Figure 1 ) such that:

1 CIN ≤ R2 Cf

Since it is often difficult to know the exact value of C

IN,Cf can

be experimentally adjusted so that the desired pulse re-

sponse is achieved. Refer to the LMC660 and the LMC662

for a more detailed discussion on compensating for input ca-

pacitance.

CAPACITIVE LOAD TOLERANCE

Direct capacitive loading will reduce the phase margin of

many op-amps. A pole in the feedback loop is created by the

combination of the op-amp’s output impedance and the ca-

pacitive load. This pole induces phase lag at the unity-gain

crossover frequency of the amplifier resulting in either an os-

cillatory or underdamped pulse response. With a few exter-

nal components, op amps can easily indirectly drive capaci-

tive loads, as shown in

Figure 2.

Stability vs

Capacitive Load

V = ±10)

DS011136-43

DS011136-5

FIGURE 1. Cancelling the Effect of Input Capacitance

LMC6041 bảng dữ liệu(PDF) 7 Page - National Semiconductor (TI)

LMC6041 bảng dữ liệu(HTML) 7 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

bảng dữ liệu tải về

Link URL