YRM2.DIODE

Y-Series

Recommendations for the configuration of redundant power systems:

•

Use separate input fuses for each power supply.

•

Use three-phase power supplies to gain functional safety if one phase fails.

•

When single-phase power supplies are utilized connect them to different phases or mains circuits if possible.

•

Set the power supply in “Parallel-Use” mode if this feature is available

•

It is desirable to set the output voltages of all power supplies to the same value.

The unit is designed to supply any kind of loads, including unlimited capacitive and inductive loads.

1+1 Redundancy up to 10A requires two 10A power supplies and one YRM2.DIODE redundancy module.

Fig. 18-1 Wiring diagram, 1+1 Redundancy, 10A output current

Failure

Monitor

10A

Load

optional

I

I

L

N

PE

YRM2.DIODE

+

-

OUT

+

-

IN 1

+

-

IN 2 IN 1 IN 2

L N PE

10A

Power Supply

+ +

- -

24V, 10A

L N PE

10A

Power Supply

+ +

- -

24V, 10A

Note: Use separate mains systems for each power supply whenever it is possible

Apr. 2014 / Rev. 1.4 DS-YRM2.DIODE-EN

All parameters are specified at 24V, 20A output current, 25°C ambient and after a 5 minutes run-in time unless otherwise noted

www.pulspower.com Phone +49 89 9278 0

Germany

15/19