GAMEWELL-FCI

12 Clintonville Road, Northford, CT 06472-1653 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118

Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.

©2013 by Honeywell International Inc. All rights reserved.

www.gamewell-fci.com

9020-0617 Rev. J page 1 of 2

ASD-PL2F, ASD-PTL2F

and ASD-PL2FR

Analog, Addressable Photoelectronic

Smoke Sensor

APPROVED

FM

3023594

SIGNALING

7272-1703:0121

S1913

MEA

Approved

FDNY

COA #:219-02-E

Vol.VI

Description

able plug-in smoke sensors with integral communica-

tion provide features that surpass conventional

sensors. Sensitivity can be programmed in the con-

trol panel software, and is continuously monitored

and reported to the panel. Point ID capability allows

each sensor’s address to be set, providing exact

locations for selective maintenance when the cham-

ber contamination reaches an unacceptable level.

The ASD-PL2F photoelectric sensor’s unique optical

sensing chamber is engineered to sense smoke pro-

duced by a wide range of combustion sources. Dual

electronic thermistors add 135°F (57°C) fixed-tem-

perature thermal sensing on the ASD-PTL2F model.

that substantially increases the speed of communica-

tion between the sensors and certain Gamewell-FCI

analog addressable fire alarm controls. These

devices operate in a grouped fashion. If one of the

devices in the group has a status change, the panel’s

microprocessor stops the group poll and concen-

trates on the single device. The net effect is a

response speed up to five times greater than earlier

designs.

Ordering Information

Part Number Description

ASD-PL2F

Analog, addressable photoelectronic

smoke sensor

ASD-PTL2F Analog, addressable photoelectronic smoke

sensor with thermal sensing

ASD-PL2FR Analog, addressable photoelectronic smoke

sensor used with the DNR duct base when

the remote test is required.

Features

•

Sleek, low-profile design.

•

Visual rotary, decimal switch addressing (01-159).

•

Built-in functional test switch activated by an external

magnet.

•

Bicolor LEDs flash green whenever the sensor is

addressed, and light steady red on alarm.*

•

Optional relay, isolator, or sounder bases.

•

Low standby current.

•

Analog addressable communication.

•

Stable communication technique with noise immunity.

•

Optional remote, single-gang LED Indicator (RA100Z).

•

Compatible with Gamewell-FCI analog addressable

panels.

Note: *Only the red LED is operative in panels that do not operate

in Velociti

ASD-PL2FR

ASD-PL2F/ASD-PTL2F