408-10096

Terminal Lubricator Assembly 1752477-1

Rev B

2 of 2

Tyco Electronics Corporation

Figure 3

Also, some terminals may require “selective

lubrication.” The bowl assembly can be removed from

the mounting bracket, rotated 90

_, and re–installed.

To adjust the wick side–to–side, the bowl assembly

need not be fully seated in the bracket. The

thumbscrew can be loosened, the bracket shifted

slightly side to side, and the thumbscrew

re–tightened. An example of a terminal that benefits

from selective lubrication is shown in Figure 3.

3.2. End-Feed Installation

For end–feed applications, the lubricator bowl drops

into the terminator base as shown in figure 4.

Figure 4

The wick height may be adjusted vertically as desired

to remain in constant, or intermittent, contact with the

incoming terminal strip. Usually, intermittent contact is

sufficient as some lubrication residue may remain on

the crimp tooling for several cycles.

4. ADDING LUBRICANT

When the lubricator bowl is either empty or nearly

empty, unscrew the cap and refill with E807 lubricant.

This lubricant is available from:

Stoner Inc.

1070 Robert Fulton Hwy,

Quarryville, PA 17566

Phone: 800–227–5538

Fax: 717–786–9088

www.stonersolutions.com

Be sure the seal is in place in the cap before

reassembling to the bowl.

Wipe off any excess lubricant and place the bowl

assembly in the side– or end–feed position.

5. REPLACEMENT

It is recommended that a spare bowl and wick be kept

on hand.

The bowl part number is currently 1804265–1. The

wick part number is currently 1804374–1. These

numbers can also be found on drawings 1752477

(Terminal Lubrication Kit) and 1804265 (Lubricator

Assembly).

6. REVISION SUMMARY

Since the previous release of this document:

corporate requirements

Leadmaker and AMP–O–LECTRIC Servo

Terminator III Machine

NOTE

i